d&b solutions

This audio in/out interface with contact closures connects to an existing matrix or other analogue interfacing products. A 4-wire intercom can be connected to the dual in/out 3-pin XLR ports. This allows two separate audio signals (or a stereo signal) to be injected into the Green-GO network and transmitted to any other location on the same Ethernet network.

The Green-GO Beltpack X features a high-resolution full colour OLED display which shows information about channels, cue signals and the different functions that are operated by the four buttons on the front of the Beltpack. These buttons can be configured to provide instant access to up to four channels. Two rotary encoders are located on either side of the Beltpack X, making it suitable for both left- and right-handed users. By pushing the encoders, the Beltpack X can answer the most recent audio source. The encoders can also be programmed to control various other functions, e.g. one encoder can be set up for level control while the other encoder controls channel selection. All matrix data is held within the device. The Beltpack X is powered through a Power over Ethernet connector located on the back. Also located on the back is a 4-pin XLR headset connector.

The Multi-Channel Rack Station has an internal loudspeaker. A 3-pin XLR microphone connector on the front panel allows you to connect a stalk microphone (not supplied). On the back panel are two Ethernet LAN ports with an internal 100MB switch. There is also a GPIO connection located on the back of the device (2x in, 2x out).

The Multi-Channel Desk Station has an internal loudspeaker. A 3-pin XLR microphone connector on the front panel allows you to connect a stalk microphone (not supplied). On the back panel are two Ethernet LAN ports with an internal 100MB switch. There is also a GPIO connection located on the back of the device (2x in, 2x out).

The BC6 19“ Rack charger can charge up to six NRGP batteries for WBPX Wireless Beltpacks. The LED Status Indicator informs the user whether a battery is still charging or is already fully charged.

The Green-GO Wireless Antenna is part of the Green-GO wireless communication system and is based on DECT technology. One Wireless Antenna serves up to four Wireless Beltpacks and each Wireless Beltpack X can be connected to four Wireless Antennas. The Green-GO Wireless Antenna can also integrate the Wireless Beltpack X into an existing wired network by simply plugging in the Wireless Antenna and cloning the configuration to the Wireless Beltpack(s).